Menu
Contact
Location
Search
New Marine Power Systems

C12 ACERT

Request A Quote
C12 ACERT High Performance
Select Units

Overview

Cat® C12 ACERT Diesel Marine Propulsion Engines, with ratings of 669-715 mhp (660-705 bhp) at 2300 rpm, meet IMO II emission standards. The C12 takes full advantage of the electronically controlled unit injection fuel system, resulting in an environmentally friendly engine with outstanding performance and fuel economy. There is also a wide range of optional equipment available to meet the needs of your specific pleasure craft application.

Ratings

  • Power Range 660-705 bhp (492-526 bkW) 660-705 bhp (492-526 bkW)

Engine

  • Speed Range 2300 rpm 2300 rpm
  • Emissions IMO II IMO II
  • Aspiration TA TA
  • Bore 5.1 in 130.0 mm
  • Stroke 5.9 in 150.0 mm
  • Displacement 732.0 in³ 12.0 l
  • Rotation from Flywheel End Counterclockwise Counterclockwise
  • Configuration In-line 6, 4-Stroke-Cycle Diesel In-line 6, 4-Stroke-Cycle Diesel

Dimensions & Weights

  • Dry Weight 2588.0 lb 1174.0 kg
  • Height 39.5 in 1005.0 mm
  • Length 62.0 in 1574.0 mm
  • Width 38.1 in 969.0 mm

Less visible white or black smoke

Lower compression ratio, resulting in less steady state smoke

Improved transient response

Standard Caterpillar warranty

Parts and service support from worldwide dealer organization

C12 ACERT Standard Equipment

Air Inlet System

  • Aftercooler - sea water; corrosion resistant, Air Cleaner/Fumes Disposal (closed system), Turbocharger, Jacket Water Cooled

Control System

  • Electronic governing, Cold mode start strategy, Power compensation for fuel temperature, Programmable low idle, Electronic diagnostics and fault logging, Engine and transmission monitoring (speed, temperature, pressure), Fuel/air ratio control, Emergency stop switch (A&B ratings only)

Cooling System

  • Thermostat and housing, Jacket water pump; gear driven, Sea water pump; rubber impeller; self-priming; gear-driven, Integral heat exhanger/expansion tank; removable tube bundle; replaceable copper-nickel tubes, Keel cooling - combined circuit (includes pipe thread flange kit)

Exhaust System

  • Watercooled Manifold & Turbocharger

Flywheels & Flywheel Housings

  • Flywheel; SAE No. 1; 113 teeth, Flywheel housing; SAE No. 1 (10 degree slant pad), SAE standard rotation

Fuel System

  • Fuel filer; RH service on Port; LH service on Starboard, Fuel transfer pump, Fuel priming pump, Flexible fuel lines

Lube System

  • Crankcase breather, Oil cooler, Oil filter; spin-on; RH service on Port; LH service on Starboard, Oil filler, Dipstick; RH service on Port; LH service on Starboard, Oil pump; gear driven

Mounting System

  • Front support

Power Take-Offs

  • Hydraulic pump drive; SAE A; 11 tooth spline, 57 ft-lbs max torque; counterclockwise as viewed from the rear of hte engine looking into the pump drive and turns 1.41 x engine speed, Crankshaft pulley; 345 mm (13.6 in) single groove; 15.88 mm (.63in) width

Protection System

  • Shutdown; electronic; 12 or 24 volt; energized to run

General

  • Vibration damper, Lifting eyes, RH or LH service options, Literature, Variable engine wiring, Upper rear-facing customer wiring connector and ECAP connection, Electronic installation kit (connectors, pins, sockets)

C12 ACERT Optional Equipment

Air Inlet System

  • Low Profile Air Inlet Line, Shield (Air Inlet Line)

Charging System

  • Charging Alternators, Voltmeter Guages, Voltmeter Guage Mounting, Alternator Mounting Group

Cooling System

  • Sea Water Pump, Coolant Recovery Tank, Flange Kit

Exhaust System

  • Flexible Fitting, Elbow, Dry Elbow, Watercooled Elbow, Exhaust Connection, Exhaust Outlet Pipe, EXH Outlet Flange, Rain Cap, Muffler

Fuel System

  • Fuel Cooler, Fuel Connections, Primary Fuel Filter, Primary Fuel/Water Separator

Instrumentation

  • OEM Wiring Harness, Engine to Engine Harness, Digital Tachometer, Tachometer Mounting, Magnetic Pickup, RH 4 Hole Instrument Panel, LH 4 Hole Instrument, Marine Power Display System, Marine Power Display Unit (for additional monitoring stations), Marine Power Display Bracket, Wiring Group, Transmission Sensors

Lube System

  • Manual sump pump, Transmission oil cooler

Mounting System

  • Vibration Isolators

Power Take-Offs

  • Crankshaft Pulley, Front Stub Shaft, Front Stub Shaft & Pulley

Starting System

  • Air Pressure Regulator, Air Start Silencer, Start Switch, Jacket Water Heater, Battery sets (24 volt - dry)

General

  • Wiring Harness Removal, Belt Guard - Alternator, Belt Guard - Alternator Pulley, Filter Cover Kit

Packing

  • Overseas Preservation, Engine Protective Cover, Storage Preservation, Export Packing

News & Events

View the latest company and product news, events and customer stories.

Promotions

View the latest offers available on a range of Cat® equipment and genuine parts.

Social Media

Connect with us to learn more about our company, products, services and customers.

Branch Locations

With branches across the UK & Ireland, you can be sure that we’re never far away.

Services

Effectively manage your equipment to reduce operating costs and improve efficiency.

Technology

Integrated technology can help you understand your equipment's output and help extend its lifespan.

Finance

Quick and easy financing with customised payment plans through Cat Financial.

Please share your feedback on Finning.com!

Close window

We are committed to providing you with the best site experience possible.  Please take our brief survey to tell us how we are doing.

Thank you in advance for your time!